汉中附近有没有服务

Hello, welcome to visit rotary kiln manufacturer!

About us | contact us | Online consultation |
Hotline: eighteen billion six hundred and thirty-seven million three hundred and two thousand and ninety-nine

News Center

Current location: Rotary kiln > News Center >

Do you know the daily management of rotary kiln

Author: admin Release time: 2016-12-08 09:56 Number of visits:

zero
        Rotary kiln Do you know something about daily management? Let's have a look at it! May be helpful to you in the use of Oh! First of all, this paper introduces the daily management of rotary kiln from the three management angles of team, section and branch plant.
Do a good job in the spot inspection, recording and reporting of the equipment. The workers should carefully implement the inspection procedures of rotary kiln, and do a good job in the spot inspection, recording and reporting of the equipment. The problems that can not be solved by the team should be reported and recorded in time according to the priority, so as to ensure that the hidden dangers of the equipment can be solved in time or the development trend can be controlled. It is the most basic work requirement for the monitor to set a good example and perform the supervision and assessment of the team. Do a good job in equipment spot inspection, record and report work, seriously implement rotary kiln inspection procedures, do well in equipment spot inspection, record and report work, timely report and record the problems that can not be solved by the team according to the priority, so as to ensure that the equipment hidden danger can be solved in time or the development trend can be controlled. It is the most basic work requirement for the monitor to set a good example and perform the supervision and assessment of the team.
      If the clearance is too large, the following adverse consequences will occur: if the clearance is large, the long-term axial movement of the belt on the base plate will lead to some iron blocks being toppled off one after another, and the belt will continue to move axially. When the belt has a large offset to one side on the supporting wheel, the bearing state on both sides of the supporting wheel will have a large deviation, and the bearing bush with large force will become thinner or damaged Bearing bush temperature rise or burning. If this happens in the middle gear, the bearing bush overtemperature or burning is most likely to occur. If it occurs in the front and rear gears, the bearing bush heating phenomenon will be alleviated. In May 2015, the first gear tyre of the kiln in our company had a large axial deviation, the direction was about 120mm towards the kiln tail, and the bearing bush did not have heating. In July, the first gear tyre was reset by taking advantage of the upgrading and transformation of electrostatic precipitator. If there is a large axial displacement of the middle gear pulley, the kiln should be stopped. The production can be resumed after the tyre is reset. Otherwise, the tile burning accident will happen at any time. However, the friction force between the bearing pad and the bearing pad will be much less than that of the conventional pulley, and the friction force between the bearing pad and the bearing pad will be much less than that caused by the axial friction between the bearing pad and the bearing pad, which will cause serious friction between the bearing pad and the bearing pad. Therefore, we must treat it with caution.
Because of time Rotary kiln I'd like to introduce you to this. If you want to know more, please continue to pay attention to us.

 Cement rotary equipment  The production and operation of environmental protection rotary kiln is stable,

Related products